T-REX-600
Instructions:Specification:
¡ñFeatures
1.Bump resistance plastic canopy. Canopy also features a rigid easy clip on/off design for fast installation and removal.
2.Simple and light weight design provides awesome flight performance nearly equal to larger helicopters while still maintaining very stable hovering and flight.
3.+-14¡ã collective pitch is possible for extreme 3D performance.
4.Clutch, Fan and Bell assembly provide a very smooth operation even at high RPM.
5.Forward mounted tail servo helps to keep exhaust oil from entering servo also improves the CG.
6.Pitch and All servos moved forward for CG.
7.Battery tray designed for easy and clean radio gear installation.
8.Fuel Tank Capacity 440cc for about 10 minutes 3D flying.
9.Main Gear Radio 8.5:1, 1500-2200 Rotor RPM.
10.Heavy duty tail with thrust bearings.
11.95mm Tail Blades.
12.Belt driven tail for incredible 50 sized performance.
13.Rigid frame design that can also handle hard crashes without damage.
14.G-10 3K Fiber frames, fins and boom supports.
15.Super engine cooling system features large diameter fan and very efficient airflow to provide unequaled cooling and horsepower.
16.Clutch/Start shaft feature a 10mm ID one way bearing to eliminate any bearing problems during starting and flight.
17.Ready to fly weight (no fuel) is an incredible 3.20Kg (7lbs).
18.Fuel Tank designed so that no additional header tank is required.
19.New main gear with one-way bearing design for high torque.
20.New flybar paddles feature light weight and sports.
21.New flybar control set design.
22.New tail boom supports.
¡ñLength:1160mm
¡ñHeight:410mm
¡ñMain Blade Length:600mm
¡ñMain Rotor Diameter:1350mm
¡ñTail Rotor Diameter:240mm
¡ñEngine Pinion Gear:20T
¡ñAutorotation Tail Drive Gear:180T
¡ñDrive Gear Ratio:8.1:1:4.5(E:M:T)
¡ñFlying Weight:Approx. 3200g
Accessories:
¡ñT-REX 600 Nitro Kits SetX1 set(w/o main blade)
¡ñBump resistance plastic canopyX1
¡ñFeul tubeX1
¡ñFuel filterX1
¡ñNew Fuel tube clip(A)X1
¡ñNew Fuel tube clip(B)X1
¡ñNew landing skidX1
Radio transmitter and electronic equipment required for assembly:
¡ñTransmitter(6-channel or more, helicopter system)
¡ñReceiver(6-channel or more)
¡ñStandard servoX4
¡ñHead lock gyroX1
¡ñSpecialized servoX1
¡ñ600 bladeX1set
¡ñPitch gaugeX1
¡ñ50 mufflerX1
¡ñ50 engineX1
¡ñEngine starter/Starter shaftX1
¡ñ11.1~14.8V Li-Po 2500mAh starter batteryX1
¡ñ2 in 1 regulator(RX and Glow plug power)X1
¡ñ7.4V 1900mAh Li-Po battery for regulatorX1
¡ñFuel pumpX1
¡ñEngine fuelX1